Dishwasher Repair Cost Breakdown Guide

Dishwasher repair cost by frame, rows apart.

Orange County, CA · Updated 2026 · Costs shown as ranges — your quote will vary by firm and scope

Reading this guide: every figure below is a range from published pricing data — not a quote. Two frames are named apart and never blended: Frame A (the Angi frame) and Frame B (the HomeAdvisor frame). The frames count the same visit differently; that difference is named on every page. Always get 3 written quotes.

Frame lines, Frame A

Frame line row, Frame AReadingFrame A note
Average repair visit$225as printed
Full range$75-$600as printed
2026 normal range$175-$325as printed
Labor$75-$125 per houras printed
Diagnostic / minimum service$50-$80as printed

The labor and diagnostic lines stand apart: Frame A prints labor at $75-$125 per hour beside diagnostic and minimum service fees at $50-$80. Frame B prints technician labor at $75-$100 per hour and plumber labor at $50-$300 per hour, beside diagnostic fees at $35-$100 that the frame prints as applied toward the total repair figure when the work goes ahead -- the same visit counted on different labor lines in two frames, never merged.

Frame lines, Frame B

Frame line row, Frame BReadingFrame B note
Average repair visit$200as printed
Most visits$160-$300as printed
Low / high end$70 / $600as printed
Technician labor$75-$100 per houras printed
Plumber labor$50-$300 per houras printed
Diagnostic fees$35-$100as printed

Frame B holds its average at $200 against Frame A's $225 -- a headline difference standing as printed, never averaged into one visit figure.

Part lines behind the breakdown

Part rowFrame A readingFrame B reading
Headline bandaverage $225; range $75-$600average $200; most $160-$300
Drain pump$150-$350$150-$350
Inlet valveno priced row printed$80-$125
Spray arm$75-$150$75-$100
Door latch / gasketlatch $75-$175gasket $50-$100
Heating element$150-$300$150-$250
Control board / panel$200-$400$200-$600
Motor$250-$600$400-$600

The part side stands across both frames, apart: Frame B prints the inlet-valve and gasket rows Frame A never prints, and Frame A prints the sensor row Frame B never prints, each as printed.

Line against line, frame against frame

A diagnostic line at $50-$80 in Frame A against a diagnostic line at $35-$100 in Frame B -- one visit, priced apart by frame line. The frames price the same visit apart -- Frame A prints repair-type lines (a pump line at $150-$350, a motor line at $250-$600) and no problem table at all; Frame B prints a problem table (a not-draining line at $50-$400, a start-failure line at $100-$600) and a part table with an inlet-valve row at $80-$125 and a gasket row at $50-$100 that Frame A never prints; Frame A prints a sensor line at $100-$200 that Frame B never prints as a part row -- a frame difference, never averaged, never blended.

The local read

The local read: the frames above are national published frames; a written quote for one address and one dishwasher line is the only local figure.

Reading a quote

Cost guide, not advice: ranges compiled from published pricing data; your price varies with the part, the problem, and the firm as quoted. No firm, brand, or product is endorsed, rated, or recommended here. Ranges only, not quotes.

Frequently asked questions

What does the dishwasher repair breakdown print at, as reported?

Frame A prints an average at $225, a full range at $75 to $600, a normal range at $175 to $325, and labor at $75 to $125 per hour. Frame B prints an average at $200, most at $160 to $300, ends at $70 and $600, and technician labor at $75 to $100 per hour, each apart.

What do the labor lines print at, as reported?

Frame A prints labor at $75 to $125 per hour. Frame B prints technician labor at $75 to $100 per hour and plumber labor at $50 to $300 per hour -- two labor counts inside Frame B, apart from Frame A's single line.

What do the diagnostic lines print at, as reported?

Frame A prints diagnostic and minimum service fees at $50 to $80. Frame B prints diagnostic fees at $35 to $100, printed as applied toward the total repair figure when the work goes ahead, each apart.

What does the FAQ variant of Frame A print at, as reported?

The Frame A page family carries an FAQ variant reading an average of $200 with most at $160 to $300, standing apart from the national page's own headline at $225 with a normal range at $175 to $325 -- two readings in one family, never merged.

Is washing-machine repair priced on this guide?

No. Washing-machine repair is its own appliance visit on the standing washing-machine cluster, a different purchase, never a frame line; the appliance-repair hub, the dryer and garbage-disposal repair clusters, and the repair-vs-replace decision page stand apart.

Related guides